background image

A l l e g r o   W a s h e r   A C   5 0 W

M o u n t i n g   G u i d e

www.traxontechnologies.com

©2020 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE 
WITHOUT NOTICE.

Mounting Guide

01/20 V0.4

3 of 4

5cm

(Minimum Bending Radius)

(Non-Bendable Length)

4D

D

To properly bend the cable:

• 

Cable must NOT bent below the Minimum Bending Radius 

Non-Bendable Length of 5cm near the connector end MUST be 
adhered to.

• 

Note the minimum bending radius for conductors > 1.5mm

2

.

• 

Pull forces on the contact points can be avoided by bending 

the wire as required.

0.8 - 1.0 Nm
0.6 - 0.7 lb ft

25mm/1”

8mm/0.3”

30mm/1.2”

8mm/0.3”

0.8 - 1.0 Nm
0.6 - 0.7 lb ft

0.8 - 1.0 Nm
0.6 - 0.7 lb ft

Avoid vertical placement of the connectors.
If vertical installation is unavoidable:

• 

Add 

silicone

 glue on the surface of cable gland.

• 

Layout the cable to have drip loop to allow water run off

 

the wire.

XB.AC.3106000 (for cable OD 6-10mm)
XB.AC.4006000 (for cable OD 10-14mm)
3-pin Field Installable AC Female Connector IP66

XB.AC.2303000 
5-pin Field Installable AC Female Connector IP66 
(for cable OD 10-14mm)

XB.AC.2302000 
5-pin Field Installable AC Male Connector IP66 
(for cable OD 10-14mm)

Remember to tighten cable gland after installation.
Make sure the cable gland also tighten the cable 
sheath.

Applicable to Field Installable Connectors.

Silicone Glue

Silicone Glue

Do no put excessive force or
install connectors in a vibrating
environment.

30mm/1.2”

8mm/0.3”

8mm/0.3”

25mm/1”

30mm/1.2”

8mm/0.3”

8mm/0.3”

25mm/1”

10-14mm/0.4”-0.55”

10-14mm/0.4”-0.55”

6-10mm/0.24”-0.4”

10-14mm/0.4”-0.55”

Summary of Contents for Allegro Washer AC 50W

Page 1: ... WITHOUT NOTICE Mounting Guide 01 20 V0 4 1 of 4 12mm screw X3 not included 75mm 2 95 Unlock Lock Lock Unlock Adjust Position 1 2 6mm Hex Key Tightening Torque 3 5Nm Only turn enough to unlock Do not unscrew the hex screw from fixture 20mm 0 8 R 6 5 m m 0 3 170mm 6 7 270mm 10 6 Φ 2 3 5 m m 9 3 203mm 8 0 317mm 12 5 Φ 1 3 m m 0 5 1 25m 2 5m 1 25m obstacle 75mm 2 95 1 Tilt the head slightly to mount t...

Page 2: ... S PATENTS E U PATENTS JAPAN PATENTS OTHER PATENTS PENDING SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE Mounting Guide 01 20 V0 4 2 of 4 CLICK 3 4 AC In DMX In DMX Out Interconnection Cable Only turn enough to unlock Do not unscrew the hex screw from fixture Butler S2 Optional stainless steel safety cable not included ĭ1 5 2 3mm 0 06 0 09 Data Injector Do not obstruct vent hole ...

Page 3: ...0 3 0 8 1 0 Nm 0 6 0 7 lb ft 0 8 1 0 Nm 0 6 0 7 lb ft Avoid vertical placement of the connectors If vertical installation is unavoidable Add silicone glue on the surface of cable gland Layout the cable to have drip loop to allow water run off the wire XB AC 3106000 for cable OD 6 10mm XB AC 4006000 for cable OD 10 14mm 3 pin Field Installable AC Female Connector IP66 XB AC 2303000 5 pin Field Inst...

Page 4: ...Ȁ ȉ ǿ Ȁ ǹ Ȃ ȅ ȃ ȅ A A N S L U I T E N O P H E T L I C H T N E T C O N F O R M D E N A T I O N A L E R E G E L G E V I N G A L S H E T E X T E R N E F L E X I B E L E S N O E R V A N D E Z E A R M A T U U R B E S C H A D I G D I S M A G D I T U I T S L U I T E N D W O R D E N V E R V A N G E N D O O R D E F A B R I K A N T O F E E N A N D E R E G E K W A L I F I C E E R D E P E R S O O N O M R I S ...

Reviews: