DVL Ember-Fyre Burner
Installation Instructions
(SKU
96900107,
96900109)
Page 2 of 6
17601695.docx — 11/19/13
© Travis Industries, Inc.
Log Set Installation
!
The logs are fragile, especially after being exposed to heat.
•
Make sure the gas control valve is “OFF” and the heater is cool prior to conducting service.
•
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
•
If using propane (LP), convert the appliance before installing the logs.
•
The burner must be correctly positioned before installing the logs. Make sure the burner is fully
seated and the pilot is properly aligned.
Right Log Bracket
Bend
the
log
bracket
up
to
90
°
as
shown
below.
Rear Log Placement
The
rear
log
has
two
obround
holes
on
the
bottom.
Place
the
log
so
the
pins
on
the
burner
insert
into
the
holes
on
the
log
(see
photos
below).
Once
in
place,
carefully
pull
the
log
all
the
way
forward.
This
allows
the
log
to
glow
above
the
rear
burner
holes.
NOTE:
If
you
encounter
sooting
on
the
rear
log,
move
the
log
back
until
sooting
is
eliminated.
