Page 3 of 3
1.3 Installing the Remote wall mount Transmitter
1 Install the Wall Mount bracket horizontally onto the wall using the screws provided. See figure 4.
2 Slide the Wall Mount Transmitter onto the Wall Mount bracket as shown is figure 5.
figure 4
figure 5
AM
SET TEMP
F
ROOM TEMP
TIMER
Figure 3
FIREPLACE REMOTE
PRESS
TO OPEN
OFF
ON
REMOTE
BAT.LOW
PRESS
TO OPEN
BAT.LOW
OFF
REMOTE
ON
3 Installing the Remote Receiver to a Wall Mount:
- Secure the Remote Receiver to the wall mount.
- Use the screws provided to secure the face plate to the Remote Receiver. See
Figure 2
.
4 Put the switch cap to the slide switch.
5 Slide the battery compartment into the Remote Receiver. See
Figure 3
.
Figure 2
Installation of the
Receiver to a
Junction Box
FIREPLACE REMOTE
PRESS
TO OPEN
OFF
ON
REMOTE
BAT.LOW
1.2 Installing the Receiver for Gas Fireplace or Insert Wall Mount
1 Make sure the slide switch on the Remote Receiver is at the OFF position.
2 Gas Appliance Receiver Wire Installation (See
Figure 1
)
We recommend the receiver wires to be installed in a parallel circuit with the on/off switch (switch must
be in "OFF" position for remote to work). See the directions below for this type of installation..
Figure 1
Remove the
wires from the
on/off switch.
Attach the wires removed in
step "a" to the "Y" jumper wires
and attach the jumpers to the
on/off switch (orientation does
not matter).
Receiver
Wires
Back of
on/off switch
Attach the receiver wires to
the "Y" jumper wires
(orientation does not matter).
"Y" Jumper
Wires