15
www.travelander.com.au
• To attach main annex roof when camper is open - stand at the LH door entrance, then
put an extended tent pole through the eyelet of zipper above doorway. As one person
holds the annex roof out straight, the other person pushers the zipper by moving the
pole along the roof edge. When the person gets to the centre or apex then the person
that is holding the roof up must lower so the 2 zippers are running together. This will
make the zipper run easier as you move it along.
• The zip to attach the annex roof begins near the door of the camper, zip across the top of
the roof towards the right side. If you wish to zip this on when camper is being opened,
lift roof to
the open position, lift top floor until you can see the zip runner. Lock roof zip
to camper zip, and then as you open the camper, zip the roof to the tent.
Erection of annex roof
• Zip the annex roof to the camper as explained above.
• Extend one tent pole next to the camper to match the height of the centre tent bow.
• Continue this for the tent bow over the door and the tent bow over to the right.
• 1st erect the centre, highest pole. Fit pole through inner sleeve and through the eyelet,
fit a single rope to this pole and peg to the ground.
• 2nd erect the pole opposite the camper door. Fit pole through the eyelet, fit a double
rope to this pole and peg to ground.
• 3rd erect the pole opposite the LH corner. Fit pole through the eyelet, fit a double rope
to this pole and peg to the ground.
• Measure the three front poles of the annex against the top of the annex wall. This will
ensure the front height is correct.
• Set up the three front poles, double ropes on the corners and a single rope in the middle.
• Adjust poles so the bottom of the annex roof is horizontal.
Attaching annex walls
• Fit annex walls in the following order
•
Wall 1, Wall 2, Wall 3, proceed with Draft Skirt, then Wall 4. Ensure velcro is fitted
correctly with no gaps or bunching. Peg walls to the ground using the black loops
supplied with camper in long draw. Feed these throw the eyelets and tie a half hitch or
not in them and put the peg through this and not the eyelets on the annex walls.
• Please note: - Wall 1, starts at entry door.
Removing annex roof and annex walls
• Remove all walls from the annex roof and prepare camper for closing.
• Remove all annex poles and ropes from annex roof. Leaving 3 on RH camper roof extension.
• Remove all annex pegs from ground and place ropes, pegs and poles in storage.
• Unzip annex roof starting from RH side.
• Fold up and place in storage.
