23
OPERATING THE SLIDE-OUT ROOM
EXTENDING THE SLIDE-OUT ROOM
Before operating your slide out room the camper must be level and stable. The switch for the slide-out room is
located by the entry door in the lower right side of the camper as you enter.
NOTE:
Your battery needs to be adequately charged and connected to your 110-volt power, to ensure proper
function of the slide-out mechanism.
1. Level your camper. If the camper is not leveled, it could damage the slide out room, seals and/or slide
out mechanism.
2. Check around the room for any obstructions; both the interior and exterior of the room.
3. Pull the battery disconnect switch out.
4. Take advantage of the 110V power source
5. Locate the slide out switch. Hold the switch in the "OUT" position until the room comes to a stop.
Release the switch.
6.
NEVER ATTEMPT TO MOVE YOUR CAMPER WITH THE SLIDE OUT ROOM EXTENDED
. This will
cause damage to the room and/or the camper.
CLOSING THE SLIDE-OUT ROOM
1. Look for any obstructions around the slide-out room both interior and exterior.
2. Locate the slide-out switch and hold in the “IN” position until the room is in and comes to a stop.
Release the switch.
3. You’re slide out room should be securely closed and ready for travel.
OPERATING THE ROOF LIFT SYSTEM
Fold-down truck campers are equipped with a roof lift system. This system is lubricated and sealed
at the factory and no additional maintenance is required.
NOTE:
Never attempt to raise the roof with the camper supported by the jacks only. The floor must be
supported. If not, the body of the camper may become distorted to the point of causing the lift system to bind
and fail.
CAUTION: Never drive with the camper roof in the raised position. This could result in damage to the
lifter system and the camper body. This damage will not be covered by warranty.
RAISING THE ROOF
To operate the lift system, proceed in the following order:
1. Unlatch the 4 roof latch mechanisms. Insert the crank handle into the crank assembly located on the
exterior front wall of the camper.
2. Rotate the lift system crank handle clockwise to raise the roof.
3. Stop raising the roof when the tent canvas is visually taut.
WARNING:
Failure to release the latches before operating the lifter crank will result in damage to the lifter
system and will void the warranty
LOWERING THE ROOF
1. If camper is equipped with Fantastic Fan, turn on fan and close entrance door.
NOTE:
This will assist in
pulling the tent canvas inward as you are lowering the roof.
2. Rotate the crank handle counterclockwise to lower the roof.
3. Stop lowering the roof as needed to tuck the tent completely into the camper.
4. Continue to lower the roof until the roof rests on the camper; latch the roof latching mechanisms.
