Verifying MP Health
Chapter 3
Installing and Connecting an MP
51
Confidential—Beta Draft—
Confidential—Beta Draft—12 May 04
Verifying MP Health
After you install the MP access point and enable PoE on the Ethernet cable
connected to the MP, you can easily verify the MP’s status by observing the LEDs,
particularly the health LED. (For the location of the health LED, see Figure 5 on
page 11.)
The health LED indicates whether the MP access point is ready for operation.
●
If the health LED is green and glowing steadily, the MP has been booted
successfully by the MX switch and is ready for operation.
●
If the health LED is not steadily glowing green, contact the system
administrator for the MX switch or, if you are the system administrator, see
