666
This document is intended for Public Distribution
19473 Fraser Way,
Pitt Meadows, B.C. Canada V3Y 2V4
Chapter 3: Configuration
3-6
TR-902 Series
Tranzeo Wireless Technologies
Setup Menu
In this section you would be able to configure wireless and administrative settings
for the TR-902 Series radio.
Wireless Settings - Basic Tab, Access Point
This window displays the wireless configuration of the device. The contents are
slightly different for access point and CPE.
* Feature available only in access point wireless mode.
(1)
In the FCC Domain this setting has no effect.
Wireless Mode:
Define if your device will operate as
Infrastructure
Station
(CPE) or
Access Point
.
SSID:
The Service Set Identifier (SSID) is the name that
identifies a specific wireless LAN. Devices must have
the same SSID to communicate with each other.
Visibility Status*:
You can set your access point to be
Visible
or
Invisible
to clients.
Location:
You can set the location of the radio to be
Outdoor
or
Indoor
.
(1)
Channel*:
Select the channel that the access point and clients use.
Channel Width:
Select the channel width to use. This value must
match on both the AP and CPE.
Using TX Rate:
The transmission speed
at which the radio and access
point communicate with each other.
Note: Setting this rate below the maximum possible
does not limit bandwidth and often has a negative
impact on the operation of your network.
