10
Note:
The "LED" means the infrared light of the indoor
camera. See the figure
The following table lists the available commands and their descriptions.
The following table lists the available commands are for indoor camera only.
*
Command Description
CAM1
CAM2
CAM3
CAM4
LED ON*
LED OFF*
LED AUTO*
LED MANUAL*
Display the video of camera 1
Display the video of camera 2
Display the video of camera 3
Display the video of camera 4
Turn on the infra-red light
Turn off the infra-red light
Set the infra-red light to auto-mode. The
infra-red light turns on if the lighting condition
is not good
Set the infra-red light to manual mode
LEDs
7. Troubleshooting
You don't get a signal at all
Make sure the camera and the computer are turned on.
Make sure the power plugs are pushed all the way in.
If the camera is powered by batteries, replace all batteries
with new ones.
If the signal is poor, or there is interference
Make sure the camera and the USB receiver are within range of each
other (range of approximately 450 feet; 150 meters in a clear line of
sight).
ENGLISH
