iGPS-M Pro USER’S MANUAL
8
3. RJ45 interface
Signal Name
Pin
RS-232
2 Red
(+5VDC)
8
White (RS232 RX)
6 Green
(RS232
TX)
7 Black
(Ground)
Water-proof housing with magnet on the bottom
There are 4 magnets on the bottom side of iGPS-M Pro receiver for attaching on your
car.
The
housing
of
iGPS-M
Pro
receiver
has
waterproof,
it
can
avoid
the
water
permeates
your iGPS-M Pro receiver while you attach it outside of the car.
LED Light
There is an LED light near the output cable on the back of iGPS-M Pro receiver.
When the iGPS-M Pro supplied 5V DC power, the LED will be on. It means your PC/Lap
top or car charger start to supply power to iGPS-M Pro receiver.
Troubleshooting
When your iGPS-M Pro receiver could not operate, please follow the instruction
to do the troubleshooting as below.
1.
iGPS-M Pro receiver does not shine on the LED
z
It means iGPS-M Pro does not have power supply. Please check if the
connector plugs in properly as the step II.
2.
iGPS-M Pro receiver’s LED is flashing, but the connection between iGPS-M Pro
receiver and the E-map can not be established. Please make sure the settings
of COM Port Number and Baud rate are correct.
z
Most of E-map provides scan function to search COM Port. Please scan
it for the correct COM Port number that iGPS-M Pro receiver is utilizing.
z
The default Baud rate is 9600. For COM port, please go to the MS Windows’
device manager to check the correct COM port first.
z
If a USB cable is used to connect to PC/Lap top, please make sure the
UBS driver is installed successfully.
