1800 816 277
www.tti.com.au
10
Product HandBook
AquaDelivery
™
•
Prepare the pump engine in accordance with the selected engine’s manual supplied with your
AquaDelivery unit.
•
Ensure the 12-volt battery is fully charged and correctly connected to the pump unit’s engine. The
battery box is located behind the pump unit. Refer to the supplied pump unit’s manual and prepare the
engine for use, such as filling its tank with fuel.
Pump Operation – Petrol Engine
The AquaDelivery’s petrol pump engine is started as follows, refer to Figure 2:
•
Turn the fuel lever to ON.
•
If the engine is cold, turn the choke lever to ON.
CAUTION: Ensure the engine’s throttle is set to idle if the engine is
cold. Do not adjust the throttle to maximum speed until the engine
has warmed up.
•
Set the throttle lever to idle for cold starting. If restarting a warm engine, the throttle can be left at normal
engine operating speed.
NOTE: Ensure the ignition key is switched ON. The engine will crank
in the OFF position but will not start unless switched to ON.
•
SInsert the key and switch the engine to the START position. When the engine starts, release the key
which will return to the ON position.
•
Back off the choke lever to the OFF position.
•
Once the engine is warmed up, adjust the throttle to increase the engine speed to normal operating revs.
•
When the engine needs to be stopped, turn the key to the OFF position.
NOTE: If the engine’s battery is flat, the recoil starter can be used.
Ensure the ignition key is switched ON.
•
If the AquaDelivery is not going to be used within the next few hours, shut the system down by turning
the fuel tap to OFF.Check that all fittings, hoses, tank breather and electrical leads are secure following
transit, and are not damaged in any way.
