4
III. Operating Instructions
1.
Plug the power cord into a standard 110V outlet and turn on the heat press
by pressing the power switch located on the side of machine. Be sure your
heat press is positioned evenly on a steady and level surface. If using an
extension cord, be sure it is industrial grade.
2.
Heat transfer parameters settings.
A. Press “OK” button to enter
TEMPERATURE
setting
When the
TEMP
indicator blinks, use Up/Down buttons “ ” “ ” to set the
required temperature and then press “OK” button again to complete the
temperature setting.
B. Press “OK” button to enter
PREHEAT TIME
setting
When the
TIME1
indicator blinks, use Up/Down buttons “ ” “ ” to set the
required time for preheating and then press “OK” button again to complete
the setting.
C. Press “OK” button to enter
TRANSFER TIME
setting
When the
TIME2
indicator blinks, use Up/Down buttons “ ” “ ” to set the
required time for transferring and then press “OK” button again to complete
the setting. If you don’t need to preheat the transfer material, TIME1 and
TIME2 can be set in same values, and then the machine will be operating in
same transfer parameters in cycle.
D. Press OK button to enter into
PRESSURE
setting
The machine comes with segmented pressure mode, which can be adjusted
according to different thickness of transfer materials in bulk transfer.
Pressure value range: 0-10. (Pressure will be higher if you increase the
setting value; the suggested pressure value for textile transfer is 7. )
E. After finishing the above-mentioned settings, your machine is ready for
pressing.
3.
When the temperature reaches the set value, you can start the transfer
printing by following below steps:
A. Pull out the under plate, and place the transfer material flat onto the
silicon pad.
B. Push the under plate back into its original position.
