Transition Networks SGFEB10 Series, User Manual

Page: 5 / 25

Transition Networks SGFEB 10/100/1000 Bridging Media Converter User Guide
33601 Rev. D www.transition.com Page 5 of 25
Installation
Warning : Before installing the SGFEB, make sure that proper electrical grounding procedures have been
followed.
To install the SGFEB, perform the following steps:
1. Determine your Model number and related DIP Switch layout. See “ Configuration ” below.
2. Set the DIPs / Jumpers on the PCB. See either “ Two DIP Switch Layouts ” on page 7 or “ One DIP
Switch Layouts ” on page 6 .
3. Make the Power Connection. See “ Power Connection ” on page 8 below.
4. Determine your port connection types. See “ Port Locations “ on page 9 below.
5. Install and connect the copper cable as required. See “ Installing the RJ-45 Copper Cable “ on page 10
below.
6. Install and connect the fiber cable as required. See “ Installing the Fiber Cable “ on page 10 .
7. Continue to the “ Operation ” section on page 11 .
Configuration
SGFEB models include one of two DIP switch layouts; either a single DIP switch or two DIP switches
accessible through a cutout in the right side of the enclosure. Both DIP switch layouts are described in the
following sections.
•
Some SFP versions (SGFEB1040-230 and SGFEB1040-330) have two DIP switches.
•
Other SFP versions and the Fixed optic version (models SGFEB1040-130, SGFEB1013-130,
SGFEB1014-130, SGFEB1019-130, SGFEB1029-130, SGFEB1029-131, and SGFEB1039-130.)
have
one DIP switch.
The DIP Switch settings for both layouts are described and illustrated in the following sections.