4
Mx/E-PSW-FX-01
Tech Support: 1-800-260-1312 International: 00-1-952-941-7600
(24 hours)
Installation
-- Continued
Connect the twisted-pair copper cable
The AutoCross feature allows either MDI
(straight-through)
or MDI-X
(crossover)
cable connections to be configured automatically, according to network conditions.
•
If half-duplex mode is used, refer to the 512-Bit Rule.
•
If full-duplex mode is used, the 512-Bit Rule does not apply. The cable
lengths are constrained by the cable requirements.
1.
Locate or build IEEE 803.2™ compliant 10Base-T or 100Base-TX cables,
with RJ-45 connectors installed at both ends.
2.
Connect the RJ-45 connector at one end of the cable to the RJ-45 port on the
Mx/E-PSW-FX-01 media converter.
3.
Connect the RJ-45 connector at the other end of the cable to the RJ-45 port on
the other device
(switch, workstation, etc.).
RJ-45 port
on the other device
(switch, work station, etc.)
RJ-45 port
on the media
converter
Power warnings
WARNING: If the media converter is an IEEE802.3-2005 Powered Device (PD)
capable of receiving power via the Media Dependent Interface (MDI) leads, the
power source, connector, and cables attached to the barrel power connector must
meet the isolation requirement specified in IEEE802.3-2005.
WARNING: When powering the model MP/E-PSW-FX-01 via “Power over
Ethernet” only, a barrel cover
(provided)
must be installed on the back panel of the
converter for safety. Failure to observe this warning could result in an electrical
shock.
[email protected] -- Click the “Transition Now” link for a live Web chat.
5
Installation -- Continued
Powering the media converter
The power options for the Mx/E-PSW-FX-01 media converter are product dependent.
The following shows the various power configurations associated with each model.
Barrel Connector
5 - 50VDC
US B
Power
Back P anel
MU/E -PS W-F X-01
MP /E- PSW- F X-01
Ba ck Pa nel
Barrel Connector
5 - 50VDC
F ront P anel
Power Over
Et hernet
M/E-PSW-FX-01 Back Panel Power
MU/E-PSW-FX-01 Back Panel Power Options
Barrel Cover Cutout
Ba ck Pa nel
Barrel Uncovered
Ba rrel Cover
MP/E-PSW-FX-01 Back-Panel Barrel Safety Cover
(only on this model)
MP/E-PSW-FX-01 Back Panel Power Options
Back Pa nel
M/E-PS W-FX-01
Barrel Connector
5 - 50VDC
