LANMaster™ T16
16-Port Ethernet™ Repeater Hub
6
13
Installing LANMaster T16 at Site
NOTE: Rackmount brackets, screws, and rubber feet are provided.
To install the LANMaster T16 in 19-inch rack cabinet:
1. Install right and left front brackets on LANMaster T16 by
installing three (3) screws through each bracket into
LANMaster T16 chassis.
2. Carefully align the LANMaster T16 between the 19-inch rack
mounting rails.
3. Install LANMaster T16 by installing two (2) screws through
right front bracket and two screws through left front bracket,
using clip nuts to secure if necessary.
To install the LANMaster T16 on table or other flat surface:
1. Carefully turn LANMaster T16 to side.
2. Install four (4) rubber feet included with packing material:
•
Separate rubber feet.
•
Remove protective paper from adhesive surface on each
rubber foot.
•
Position and secure each rubber foot as shown.
3. Return LANMaster T16 to upright position.
Installing Thicknet 10BASE-5 Cable
The LANMaster T16 provides a female AUI connector at the back for
network connection to 10BASE-5 through an AUI drop cable or to
10BASE-2, 10BASE-T, or 10BASE-FL through a transceiver.
CONNECTING TO 10BASE-5 USING AUI DROP CABLE
To connect to 10BASE-5 cable using AUI drop cable:
1. Locate or build IEEE 802.3 compliant AUI drop cable.
2. Connect AUI drop cable
male connector to female
AUI (DTE) connector on
LANMaster T16.
3. Connect AUI drop cable
female connector to the AUI
port on a 10BASE-5 cable
transceiver or media
attachment unit (MAU).
4. Verify that 10BASE-5
segment is terminated at both ends using 50-ohm terminators.
CONNECTING TO NETWORK USING TRANSCEIVER
NOTE: Refer to transceiver documentation for detailed specifications.
To connect to network using transceiver:
1. Locate IEEE 802.3 compliant transceiver with male AUI
connector and with required network media connector.
2. Connect transceiver male AUI connector to the female AUI
connector on LANMaster T16.
3. Referring to transceiver documentation, connect transceiver
network media connector to the network media.
50 ohm terminator
TO FIBER, COAX,
OR TWISTED PAIR
