Twisted Pair Connector/10BaseT Connection
The twisted pair card (E-TBT-SIC) provides an RJ-45 connector to
10BaseT.
To connect 10BaseT Cable to Multi Media Repeater RJ-45 connectors:
1. Locate or build 10BaseT cables with the following
characteristics:
•
802.3 compliant (See page 18)
•
correct (straight through or crossover) cable configuration
for site installation (See page 7)
•
male RJ-45 plug connectors installed at both ends of cable.
2. Connect male RJ-45 plug connector at one end of 10BaseT
cable to Multi Media Repeater RJ-45 jack connector.
3. Connect male RJ-45 plug connector at other end of 10BaseT
cable to DTE terminal RJ-45 jack connector (using crossover
cable orientation) or to RJ-45 jack connector (using straight
through cable orientation).
Ethernet™ 2-Port
Multi Media Repeater
8
11
Installing Multi Media Repeater on Flat Surface
To install the Multi Media Repeater on table, shelf, or other flat surface:
1. Carefully turn Multi Media Repeater to side.
2. Install four (4) rubber feet:
•
Remove protective paper from adhesive surface of rubber
foot.
•
Position rubber foot at bottom corner of Multi Media
Repeater.
•
Secure rubber foot to Multi Media Repeater surface.
•
Repeat for remaining rubber feet.
3. Return Multi Media Repeater to upright position.
wall plate
#1
Straight-through 10BaseT
Crossover 10BaseT
#2
