4
CSRFB10xx-100
24-hour Technical Support: 1-200-260-1312 -- International: 00-1-952-941-7600
The Loopback Mode jumper is located on the media
converter’s circuit board
(labeled ALL= all frames
plus errors, Good = Good frames only).
See Jumper
position to the right.
Loopback test
The loopback test is an automatic test run from the center chassis converter with
SW6 set to ‘center,’ the UP position of the switch; and on the terminal converter
with SW6 set to ‘terminal,’ the DOWN position of the switch.
Note:
This test is self-running after being initiated through software on the center
converter.
The Loopback test does the following:
1.
The center converter will put the terminal converter in loopback mode.
2.
The center converter sends 100 packets to the terminal converter.
3.
The center converter will monitor its receiver for:
a.
good packets
b.
CRC errors
c.
timeouts
4.
After the center converter receives all 100 packets back or a time out occurs, it
will update its counters and return the terminal converter to its previous mode
of operation.
After completing the test, normal operation of the center and terminal converters is
established automatically.
J4
Frames
1
2
3
Good
Pins
All
All
Good
Installation -- Continued
AutoCross jumper
The AutoCross jumper is located on the media converter’s circuit board
(labeled NA =
No Autocross; A = AutoCross).
See Jumper position below.
Note:
Use small needle-nose pliers to set the
jumper.
A
Either straight-through or crossover
cable can be used for all twisted-pair
copper links.
NA
Straight-through or crossover twisted-
pair cable, depending on installed site
converters, MUST be installed at EACH
twisted-pair copper link.
Note:
Factory default is “A” enabled. Transition Networks recommends leaving
the converter in the “A” enabled position.
J7
AutoCross
1
2
3
Pins
A
A
NA
NA
[email protected] -- Click the “Transition Now” link for a live Web chat.
5
Install the slide-in-module
To install the CSRFB10xx-100 media converter slide-in-module:
1.
Locate an empty installation slot on the
PointSystem™
chassis.
2.
Carefully slide the module into the slot, aligning the module with the
installation guides.
3.
Ensure that the module is firmly seated inside the chassis.
4.
Push in and rotate the panel fastener screw to secure the module to the chassis
front.
Media Converter
Panel Fastener
Chassis
Panel Fastener
Mounting Hole
