CPSMP-130 & CPSMP-140
6
24-hour Technical Support:
1-800-260-1312
-- International:
00-1-952-941-7600
WARNING: Do NOT connect the power supply module to the external power
source before installing it into the chassis. Failure to observe this caution could
result in equipment damage and/or personal injury or death.
Replace the Power Supply Module
CAUTION: Ensure that the power supply module has been disconnected
from the external power source and the module’s On/Off switch has been
set to “0”. Failure to observe this caution could result in damage to, and
subsequent failure of, the power supply module.
NOTE:
The power supply module may be “hot swapped” (i.e., replaced while
the chassis is in operation)
provided the module to be replaced has been
disconnected from its external power source and the module’s On/Off
switch has been set to “0”.
To replace the CPSMP-130 or the CPSMP-140 power supply module:
1.
Set the On/Off switch on the power supply module to
“0”
.
2.
Verify that the external power source is
NOT
powered.
3.
Disconnect the po) terminal from the external power connector
marked “+”.
4.
Disconnect the negative (-) terminal from the external power connector
marked “-”.
5.
Disconnect the ground terminal from the external power connector
marked “chassis ground”.
6.
Rotate the attached panel fastener screw counter-clockwise.
7.
Carefully slide the power supply to be replaced out of the chassis.
I
0
-
+
I
0
-
+
+
GND
–
Power LED
External Power Connectors
On/Off
Switch
Panel Fastener Screw
I
0
-
+
I
0
-
+
7
-- Click the
“Transition Now”
link for a live Web chat.
Replace the Power Supply Module --
Continued
8.
Carefully slide the replacement power supply module into the installation
slot, aligning the module with the installation guides.
9.
Ensure that the power supply module is firmly seated inside the chassis.
10. Rotate the attached panel fastener screw clockwise to secure the power
supply module to the chassis.
11. See the “Connect to External Power” section (page 5) for instructions on
re-connecting the power supply module to the external power source.
I
0
-
+
I
0
-
+
