4
CGFEB1xxx-1xx
24-Hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Installation
CAUTION: Wear a grounding device and observe electrostatic discharge precautions
when handling the media converter. Failure to observe this caution could result in
damage the media converter.
Four-position switch
The four-position switch is located on the circuit board of the media converter. Use a
small, flat-blade screwdriver
(or a similar device)
to set the switch according to the site
requirements
(see the drawing below).
100Ba
s
e-FX Duplex: UP = Full, Down = Hal
f
LPT: UP = Enable
d
, Down = Di
s
able
d
Unu
s
e
d
S
W Po
s
i
t
ion Up
S
W Po
s
i
t
ion Down
Unu
s
e
d
1
2
3
4
1. 100Base-FX Full/Half Duplex
UP
Operates in full-duplex mode
DOWN Operates in half-duplex mode
2. Link Pass-Through (LPT)
UP
Enable Link Pass-Through
DOWN Disable Link Pass-Through
3. Not used
4. Not used
CGFEB1xxx-1xx
[email protected] -- Click the “Transition Now” link for a live Web chat.
5
Install the chassis card
1.
Remove one chassis slot cover from the Point System Chassis
(keep the slot
cover and screw)
.
2.
Carefully slide the media converter into the chassis slot, aligning it with slot
guides.
3.
Ensure that the media converter is firmly seated in the slot.
4.
Push in and rotate the panel fastener to secure the module to the chassis. See
illustration below.
Poin
t
S
y
st
em Cha
ss
i
s
Me
d
ia Conve
rt
e
r
Panel Fa
st
ene
r
S
lo
t
Hardware/software jumper
The hardware/software three-pin header J5 is located on the circuit board labeled H
and S. See jumper positions below.
Note:
Use small needle-nose pliers to set the jumper.
Hardware The media converter mode is determined by the 4-
position switch settings.
Software
The media converter mode is determined by the
most-recently saved, on-board microprocessor
settings.
S
J5
S
J5
Installation -- Continued
