CETTF10xx-105
4
24-hour Technical Support:
1-800-260-1312
-- International:
00-1-952-941-7600
Installation
-- Continued
Connect the fber cable
1.
Locate or build IEEE 803.2
™
compliant 10Base-FL fiber cable with male,
two-stranded TX to RX connectors installed at both ends.
2.
Connect the fiber cables to the CETTF10xx-105 media converter as
described:
•
Connect the male TX cable connector to the female TX port.
•
Connect the male RX cable connector to the female RX port.
3.
Connect the fiber cables to the other device (another media converter,
hub, etc.) as described:
•
Connect the male TX cable connector to the female RX port.
•
Connect the male RX cable connector to the female TX port.
Power the Media Converter
The slide-in-module media converter is powered through the Transition
Networks
PointSystem™
chassis.
Connect the fiber cable
to the media converter
as shown.
Connect the fiber cable
to the other device
(media converter,
hub, etc.) as shown
RX
TX
RX
TX
5
-- Click the
“Transition Now”
link for a live Web chat.
Operation
Status LEDs
Use the status LEDs to monitor the media converter operation in the network
PWR
(Pow
er
)
On = Connection to external AC power.
LKF (Link
-
fiber
)
On = The fiber link is up.
Off = A lack of power or a broken fiber link.
LKC (Link
-
copper
)
On = The copper link is up.
Off = A lack of power or a broken copper link.
RXF (Receive
-
fiber
)
Flashing = Data reception on the fiber link.
RXC (Receive
-
copper
)
Flashing = Data reception on the copper link.
SNMP
Use SNMP at an attached terminal or at a remote location to monitor the
media converter by monitoring:
•
Media converter power.
•
Copper link and fiber link status.
•
Copper receive and fiber receive status.
•
Hardware switch settings.
•
Fault condition.
Also, use SNMP to enter network commands that:
•
Enable/disable the copper port .
•
Enable/disable the fiber port.
•
Enable/disable AutoCross.
•
Enable/disable Link Pass Through.
•
Power down the media converter.
See the on-line documentation that comes with Transition Networks
FocalPoint™
software for applicable commands and usage at
www.transition.com.
RXC
LKF
PWR
LKC
RXF
