Transition Networks
CBFTF10xx-1xx User Guide
33403 Rev. E
https://www.transition.com
Page 4 of 15
Set 6-position DIP Switch
(SW2)
The 6-position DIP switch (SW2) is located
located on the edge of the PCB. Use a
small flat blade screwdriver to set the
recessed switches. See below for the
individual switch settings.
1. Auto-Negotiation
up Enables Auto-Negotiation on the copper port
.
Advertises the setting of switches 2 and 3.
down Disables Auto-Negotiation on the copper port. Forces the setting of switches 2 and 3.
2. Speed
(only functions whan Switch 1 is Down)
up 100 Mb/s operation on the copper port.
down 10 Mb/s operation on the copper port.
3. Copper Mode Duplex
(only functions whan Switch 1 is Down)
up full duplex operation on the copper port
.
down half duplex operation on the copper port.
(Parallel detection only with Auto-Negotiation enabled and linked to nonnegotiatingdevice)
up Parallel detects in IEEE standard half duplex.
down Non-standard full duplex.
4. Fiber Mode
up Forces full duplex operation on the fiber port.
down Forces half duplex operation on the fiber port.
5. Far-End Fault (FEF)
up FEF Enabled
down FEF Disabled
6. Link Pass Through (LPT)
up LPT Enabled
down LPT Disabled
