Installation
Carefully remove the equipment from the carton and inspect contents.
If any damage has occurred during shipment, notify the local carrier at
once. A report should also be forwarded Transforming Technologies at
419-841-9552.
The CrossFLOW is designed for portable or permanent operation. The
bench stand can be used for portable operation or bolted to a sturdy
flat surface such as a wall or under a shelf. If the bench stand is bolted
in place, use 5/16-inch diameter screws or bolts (not included) to se-
cure it.
The CrossFLOW should be placed approximately 1 to 3 feet from the
critical work area or objects to be neutralized. It should be positioned to
cover as much of the area as possible with the ionized air stream. The
air stream can be directed upward or downward by tilting the unit on
the stand. Tightening the lock knobs on each side of the unit secure it
in position.
Operation
Activate the IN3000 by setting the POWER
switch to the ON position. The ionization
indicator will illuminate to indicate the pres-
ence of ionized air. Set the air flow as de-
sired by adjusting the FAN SPEED from to
low (left) to high ( right ). If warm air is de-
sired for operator comfort, set the HEATER
switch to the ON position.
