4
Figure 4 Scan Handle Dual Battery Pack Charger
Charging-Status Light-Emitting Diode Indicators
There is one charge status light-emitting diode (LED) for each compartment. The charger LED indicators are as
follows:
•
Off
–
Battery not inserted properly, no battery installed, or battery completely run down. The LED remains
off until the battery reaches an initial charge capacity of 5%.
•
Red
–
Battery is charging.
•
Green
–
Battery charge is complete.
•
Blinking red
–
pack may not be installed in compartment properly, or pack may be faulty. If pack is installed
improperly, remove and reinsert it. If battery has been charging for five hours and the charger LED switches
from solid red to blinking red, the pack is faulty and should be replaced.
The LED may flicker as it advances from one charge state to another. When battery is fully charged, remove it
from the charger compartment.
Note: TransCore recommends that you charge the scan handle battery pack after each shift.
Charging the 700 Color Mobile Computer Battery Pack
Before using the scan handle with the color mobile computer, you need to charge the mobile computer battery
using the 700 Color Mobile Computer Single Dock/Charger station.
To charge the mobile computer battery pack using the single dock station
1.
Connect power supply unit plug to the single docking station jack (Figure 5).
Summary of Contents for Encompass 1
Page 15: ...15...
