The Encompass 1 Handheld Reader combines the TransCore Encompass 1 RFID Scan Handle and the
Intermec Model 700 Color Mobile Computer (model 741, 751, or 761 only). This document describes
procedures to set up and read tags using TransCore’s Encompass 1 Portable RFID Scan Handle with
Intermec’s Model 700 Color Mobile Computer.
This guide does not contain detailed user instructions for the mobile computer, those are
covered in the Intermec 700 Color Mobile Computer guides.
Before Getting Started
TransCore’s Encompass 1 Handheld Reader is designed to read American Trucking Associations (ATA) tags,
Wiegand-programmed tags, and TransCore eGo
®
tags.
1
The TransCore Encompass 1 RFID Scan Handle
component (P/N 10-0700-002) is identified by the TransCore logo on the faceplate (Figure 1).
Figure 1 Encompass 1 RFID Scan Handle Showing TransCore Logo
Note: If your Encompass 1 Scan Handle is not identified by the TransCore logo on its faceplate, you will not be
able to read ATA, Wiegand, or TransCore eGo tags.
Handheld Reader Setup Instructions
To set up the basic Encompass 1 Handheld Reader, you will need the following items:
•
TransCore Encompass 1 Portable 915-MHz Scan Handle with battery
•
Intermec 700 Color Mobile Computer (model 741, 751, or 761 only)
•
TagReader Demo software program loaded in the Intermec 700 Mobile Computer
1. eGo tags are fully compliant with the American National Standards Institute INCITS 256-2001 and International Organization for Standardization 18000-6 standards.
Encompass
®
1 Handheld Reader Quick Start Guide
411862-007 05/10
Summary of Contents for Encompass 1
Page 15: ...15...
