TransCore AI1422E, User Manual

Page: 44 / 102

100N Select Baud Rate
!100N selects the reader baud rate. The factory-default setting is 9600 baud . The N variable
specifies the baud rate shown in Table 7 .
Reader response: !Done
Table 7 Select Baud Rate Commands
Command Baud Rate Selected
1002 1200
1003 2400
1004 4800
1005 9600 (factory default)
1006 19.2 K
1007 38.4 K
CAUTION
If ECP is enabled, ensure that the ECP timeout is sufficient for the new baud rate. Refer to
“525 Display Communications Protocol Status” on page 6–36
.
101N Select Stop Bits
!101N
selects the number of stop bits for reader character transmission. The factory default
setting is 1 stop bit. The N variable specifies the number of stop bits as indicated in
Table 8 .
Reader response: !Done
Table 8 Select Stop Bits Commands
Command Stop Bits Selected
1010 1 (factory default)
1011 2
AI1422E Reader User Guide
TransCore Proprietary 6–28