5 of 8
Use wall plate (
AA
) as template to mark mounting
holes.The top mounting hole should be 5" above the
desired screen center as shown in figure A.1 on page 4.
Drill three
¢
10 mm dia. holes 2.6" (66mm) deep as
shown in fig.
B
.1. Insert concrete anchor (
H
secure with M6x 60 screws (
G
). Level, then tighten all
fasteners.
CU
TA
W
AY
VI
EW
INCORRECT
concrete
surface
1
3
2
H
Drill holes and insert anchors (
F
).
CORRECT
Place wall plate (
D
) over anchors (
F
) and secure with screws (
E
).
Tighten all fasteners.
wall plate
plaster/
drywall
concrete
wall plate
concrete
plaster/
drywall
Always attach concrete anchors directl to load-
bearing concrete.
Never attach concrete anchors to concrete covered
with plaster, drywall, or other finishing material. If
mounting to concrete surfaces covered with a finishing
surface is unavoidable, the finishing surface must be
counterbored as shown below. Be sure concrete
anchors do not pull away from concrete when tighten-
ing screws. If plaster/drywall is thicker than 5/8",
custom fasteners must be supplied by the installer.
WARNING
Tighten screws so that wall plate is firmly attached,
but do not overti hten. Overtightening can damage
screws, greatly reducing their holding power.
WARNING
H
G
B
CONCRETE WALL
fig. B.1
y
g
Installation to Concrete Wall
•
Concrete must have a 2000 psi density minimum. Lighter density concrete may not hold the concrete anchor.
•
Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
WARNING