Trango Systems Flacon Plus, Installation And Operating Instructions Manual, Page: 19 / 48

Copyright © 2000 Trango Systems, Inc. (All rights reserved)
18
In Power Save Standby mode the transmitter:
1. stops transmitting over the air by shutting down
the majority of its circuitry to save power,
2. periodically and momentarily powers up and
transmits over the air, and
3. waits to be returned to Normal mode by one of
the following:
•
an open condition on the Alarm 1 input,
•
the Toggle/Standby switch, or
•
the TrangoLink software.
To exit Power Save Standby mode, momentarily press the
Toggle/Standby switch, or use the TrangoLink software.
After exiting Power Save Standby mode, the active channel
LED will be on solid to indicate that the transmitter is now
continuously transmitting again. If the Power Save Timer is
still enabled, the radio will go back to Power Save Standby
when it times out again.
Data Pass-Through Mode:
The transmitter and receiver can be used to pass data at
rates from 1200 to 9600 bps. (For optimum data
transmission without losses, both the transmitter and
receiver should be configured to pass or accept data at
the same rate. The data rate and parity are configured
using the TrangoLink software.) To enter Data Pass-
Through mode, the illustrated switch should be placed in
“Alm/Data Mode On.” Then, from the TrangoLink
software, select “Pass-Through Mode.” Make sure both
the VTX5900 and the VRX5900 have been configured
for Data Pass-Through mode.