Configuration
Trango Broadband Wireless — ATLAS5010
page 14
help [<command>]
Display command usage and syntax
ipconfig [<ip> <subnet> <gateway>]
Change ip configuration
<ip> = ip address
<subnet> = subnet mask
<gateway> = gateway ip address
linktest <local tx rate> <peer tx rate>
[<pkt size> [<# of pkt> [<# of
cycle>]]]
RF link loopback test
This is the primary loopback test utility for
evaluating over-the-air link quality. Provides
link reliability information and dropped packet
statistics. Standard linktest transmits 1600 byte
packets, 1000 packets per second for 10 cycles.
User can specify packet size, quantity of
packets, number of cycles
<tx rate> = 6,12,18,24,36,48,54 Mbps
mir [<kbps>]
Set or display tx maximum information rate
(MIR). MU and RU can be set with
different mir for asymmetric upload and
download.
<kbps> = 100..50000
opmode [on|off]
Set or display operation mode (on or off)
password <ro|rw|upgrade>
Change password
<ro> = for read-only
<rw> = for read-write
<upgrade> = for upgrading firmware
peerid [<peer device id>]
Set or display peer device id
power [<dBm>]
Set or display tx power
<dBm> is limited by area (ref: “sysinfo 4”)
reboot Reboot
unit
remarks
Enter user remarks up to 80 characters
reset
Restore all factory defaults except ipconfig and
passwords.
rssi
Display RF relative signal strength indication
(rssi) from peer radio
rssiled [on|off]
Enable or disable rssi LED update
speed [<tx rate>]
Set or display tx rate
<tx rate> = 1,2,6,9,11,12,18,24,36,48,54 Mbps
survey [<sec>]
Display noise floor for current channel
<sec> = period 10..3600
default = 10
survey <sec> all
Display noise floor for all available channels
survey <sec> [<ch#> [..]]
Display noise floor for selected channels
sysinfo
Display all system information
sysinfo [[<part #> [<part #> [..]]]]
Display system information and status
<part #> = 0..6
part 0: up time and version information
part 1: MAC address and IP configuration
part 2: RF link status
part 3: channel table
part 4: region code and power limitations
part 5: switch settings and remarks
part 6: statistics
syslog
Display system log
