Safety recommendations
To avoid accidents and damage, the following recom-
mendations should be observed during maintenance
and service visits :
1. The maximum allowable pressures for system leak
testing on low and high pressure side are given in the
chapter "Installation". Always provide a pressure regu-
lator.
2. Disconnect the main supply before any servicing on
the unit.
3. Service work on the refrigeration system and the elec-
trical system should be carried out only by qualified
and experienced personnel.
Maintenance contract
It is strongly recommended that you sign a maintenance
contract with your local Service Agency. This contract
provides regular maintenance of your intallation by a
specialist in our equipment. Regular maintenance
ensures that any malfunction is detected and corrected
in good time and minimizes the possibility that serious
damage will occur. Finally, regular maintenance ensures
the maximum operating life of your equipment. We
would remind you that failure to respect these installa-
tion and maintenance instructions may result in imme-
diate cancellation of the warranty.
Training
The equipment described in this manual is the result of
many years of research and continuous development.
To assist you in obtaining the best use of it, and maintai-
ning it in perfect operating condition over a long period
of time, the constructor have at your disposal a refrige-
ration and air conditioning service school. The principal
aim of this is to give operators and
maintenance technicians a better knowledge of the
equipment they are using, or that is under their charge.
Emphasis is particularly given to the importance of per-
iodic checks on the unit operating parameters as well as
on preventive maintenance, which reduces the cost of
owing the unit by avoiding serious and costly break-
down.
The constructor's policy is one continuous product improvement, and he reserves
the right to alter any details of the products at any time without notice
This publication is a general guide to install, use and properly maintain our products.
The information given may be different from the specification for a particular coun-
try or for a specific order. In this event, please refer to your nearest office.
For additional information, contact :
Distributor / Installer stamp
All rights reserved. No part of this publication may be reproduced or transmitted in any
form or by any means without the written authorization of the constructor.
C20 IM 004 E - 1199
•
Supersedes C20 IM 004 E - 0498
Société Trane - Société Anonyme au capital de 41 500 000 F - Route de Chamagne - 88130 Charmes - France -
Siret 306 050 188-00011 - RCS Epinal B 306 050 188 - Numéro d'identification taxe intracommunautaire : FR 83 306050188
An American Standard Company
