Introduction
6
RRU-SVX01F-EN
providing properly sized relief openings; by
interlocking a powered exhaust system; or by a
combination of these methods.
•
Refer to the heater rating name plate for determining
the minimum gas supply pressure for obtaining the
maximum gas capacity for which this heater is
specified.
•
Service personal shall perform a gas leak check during
the hearer start up, to verify the gas-tightness of the
heater’s components and piping under normal
operating conditions. Refer to
for instructions.
•
The installation shall conform with local codes, or in
the absence of local codes, in accordance with the
National Fuel Gas Code, ANSI/NFPA 54, or the CAN/
CSA B149.1 Natural Gas and Propane installation
Code.
•
Where duct work is attached to the inlet of the heater
installing contractor shall confirm blower operation
provides a minimum of four air changes through
heater and inlet duct before ignition can occur.
•
If the failure or malfunction of this heater creates a
hazard to other fuel burning equipment in the
building, (e.g. when the heater is providing the make-
up air to a boiler room), the unit is to be interlocked to
open inlet air dampers or other such devices.
Information Specific to Heater Installation
•
The heater inlet shall be located in accordance with
the applicable building code provisions for ventilation
air.
•
Consult factory before installing any accessories
designed to minimize the entry of snow and rain.
•
When operating in heating mode, the unit controller
will prevent recirculation of air to the heater.
Recirculation of room air to the unit is not permitted
when the unit it operating in a heating mode.
•
If in doubt regarding the application, consult the
manufacturer.
Copyright
This document and the information in it are the property of
Trane, and may not be used or reproduced in whole or in
part without written permission. Trane reserves the right
to revise this publication at any time, and to make changes
to its content without obligation to notify any person of
such revision or change.
Trademarks
All trademarks referenced in this document are the
trademarks of their respective owners.
Revision History
•
Updated Model Number Descriptions chapter.
•
Updated System Configuration and Pre-Start chapter.
•
Updated Alarms and Troubleshooting chapter.
•
Running edits.
WARNING
Safety Alert!
Failure to follow instructions below could result in
death or serious injury. In addition to the following
tasks, you MUST:
•
Follow all instructions in the unit’s Installation,
Operation, and Maintenance manual, including
warnings, cautions, and notices.
•
Perform all required tasks in any applicable Service
Alerts and Service Bulletins.
•
Review and understand all information provided in
Submittals and Design Specifications
ATTENTION
Alerte de Sécurité!
Le non-respect des instructions ci-dessous peut
entraîner la mort ou des blessures graves. En plus des
tâches suivantes, vous DEVEZ:
•
Suivez toutes les instructions du manuel
d'installation, d'utilisation et d'entretien de l'unité, y
compris les avertissements, les mises en garde et les
avis.
•
Effectuer toutes les tâches requises dans les alertes
de service et les bulletins de service applicables
•
Examiner et comprendre toutes les informations
fournies dans les soumissions et les spécifications de
conception
