INSTALLER'S GUIDE
18-AH13D9-5A-EN
Page 4
7.
Line up the template along the center of the notch and the
edge of the front panel as shown in Figure 8.
8.
Cut out a section of the front panel inside the template
inner edge for the field connection lines as shown in
Figure 9.
9.
Cut out the fiberglass insulation over the condensate
holes. See Figure 10.
Figure 8
ALIGN THE TEMPLATE TO THE BOTTOM OF
THE NOTCH IN THE SIDE FLANGE OF THE
FRONT PANEL AS SHOWN BELOW
Figure 9
Cut along
inside edge
of template
Figure 10
