FUNCTIONAL ELECTRICAL TEST
check
should be
performed after a zone sensor has
been
mounted and the
installed. The cover must be
the
sensor is equipped with a temperature control, set the
control dial with
in
the
position.
Press either one the two pushbutton
switches on
upper
side of
the sensor. The green LED near the bottom the
circuit board should flash each
time the pushbutton is
pressed. If it does not,
check that both batteries are good and
property seated in the holders.
In normal use, the green LED will Hash each time the zone
sensor
transmits a message,
several minutes apart.
SET-UP PROCEDURE
Rater to the
sensor set-up procedures In
instructions
the Model
771211
Tool.
SPECIFICATIONS
W i i h : 5 ’
Depth:
mounting plate).
x 127mmW x 33mmD)
Range:
Nominal
feet fine-of-sight, indoors.
Two
Lithium Batteries.
Use only
No.
7010, Panasonic
Duracell 1234 or Sanyo
for
replacement.
Risk of fire, explosion and
Do not
or
of
used batteries
USER NOTE
CHANGES OR
MAOE TO THIS
WHICH ARE
NOT EXPRESSLY APPROVED BY THE AGENT FOR THE
COMPANY
RESPONSIBLE FOR COMPLIANCE WITH FEDERAL REGULATIONS COULD
THE USER’S AUTHORITY TO OPERATE THIS EQUIPMENT.
THE
COMPANY,
Commercial Systems Group
3600
Creek Road,
Lacrosse, WI 54602
Copyright
0