TEF 2898
LANTERNS USER MANUAL
INTRODUCTION
Thank you for purchasing this product!
For installation, maintenance and assurance of a long life
of this product, please follow this manual.
CONTENT IN BOX
The product is fully assembled, and ready for installation.
SAFETY PRECAUTIONS
Note that changes made to the product and/or installation
of components which do not conform to the approval,
may be a safety violation. The manufacturer will in no
circumstance be held responsible for such activity.
For your health and safety, always use safety gear suited
for the task. Be certain to follow codes, regulations and/or
specifi c procedures that are related to the installation.
TOOLS REQUIRED
Regular tools required for installation.
One small, fl at screwdriver for the electrical connections.
One small adjustable wrench for the electrical compartment
cover.
One larger adjustable wrench or an adjustable torque
wrench for the fi xing screws for the lantern to wall / mast,
and if using Tranberg stainless steel mounting bracket,
between this and the mast and the lantern.
IMPORTANT INFORMATION
Some models are supplied with galvanic isolators. These
should be placed between the lantern and the wall, thus
preventing corrosion to either. There should be used acid
resistant stainless steel fi xing screws/bolts.
Never paint lantern or any of its components.
Use only spare parts as described.
If all round lanterns are mounted upside-down, the M3
screw and washer on top of the lantern must be removed
and inserted to the drain hole at the bottom of the lantern
wich now will be the top of the lantern. See fi gure below.
MAINTENANCE INSTRUCTIONS
The lantern should be inspected according to Company
routines. The manufacturer suggests regular check for
water intrusion/condensation which should be removed
immediately. Check the drain plug / drain hole function.
When cleaning, use only mild detergents. Alcohol or
petroleum based products may damage lens, paint or
plastic components.
APPROVAL
Type approved and certifi ed by det Norske Veritas (DNV)
to be in compliance with the requirements in the Council
Directive 96/98/EC of 20 December 1996 on Marine
Equipment as amended by directive 2009/26/EC, issued
as “Forskrift om Skipsutstyr” by the Norwegian Maritime
Directorate, Annex A.1, Item No. A.1/6.1 and Annex B,
Module B in the Directive, COLREG 72 as amended, Annex
I
/14, IMO Res. A694(17 and IMO Res. 253(83). Certifi cate
Nos.: MED-B-6820 and MED-D-1497
The lantern arrive from
Tranberg AS with the M3
screw and washer mounted
on the lantern lid.
If the lantern will be mounted
upside-down, remove the
M3 screw and washer from
the lantern lid.
Insert the screw and washer
into the drain hole at the
bottom of the lantern which
is now the top of the lantern.
