TEF 2438N
LUMINAIRE USER MANUAL
INSTALLATION INSTRUCTIONS
Mount on plane surface, or on pipe 1”BSP (code 0)
Prior to the installation, remove the globe of the
luminaire. This is done by turning the globe ring/guard
counter clockwise, and then pull out both the guard and
the globe. Ensure that the silicon gasket stay on the globe
flange, as it is vital to obtain the water ingress protection.
The lamp is fastened to a structure typically by means of
two M5 bolts, spaced at 120mm. If installed on a wall,
ensure that the cable gland is pointing downwards to
minimize the risk of water ingress through the cable
gland.
Remove the bottom assembly plate inside the luminaire.
This is done by only loosening the two M3 screws, then
slightly turning the bottom assembly plate until it can be
pulled out.
Plane surface mounted
Pipe mounted
243A108262
Check that the rubber gasket inside the cable gland
matches the dimension of the cable. See the section at
bottom of the preceding page in this manual, and swicth
to a different size if required. Pull the cable through the
cable gland and connect the wires to the terminals on the
bottom assembly plate.
Replace the bottom assembly plate, while ensuring that
the cable and wires beneath it, does not get jammed when
the two screws for the bottom assembly plate are
tightened. Then tighten the cable gland nut until the
rubber gasket is firmly sealing against the cable.
Finally, test the lamp, then replace the globe and the globe
ring/guard. Please ensure that the silicon gasket is free
from foreign objects and that it is not twisted, nor
dislocated, as that may impair the water ingress rating of
the product.
