Mounting the mixer faucets
Single mixer faucet
Connect the flexible parts (5) to the water
supply with the nipples (9).
1.
2.
35mm
30 mm
7
3.
4
1
4.
6
6
5
9
4
3
6
Control
5
QUENTE
FRIO
5.
Components
Cleaning and care
• To clean the mixer faucet, use a soft cotton cloth, preferably dry. If necessary, use mild detergent/soap with a damp cloth. Rinse
the detergent/soap completely with water and dry with a soft, dry cotton cloth.
• Never use steel wool pads, abrasive products, chemicals, or solvents to clean.
• We recommend keeping the item dry after each use to prevent accumulated water to dry on the product.
• Clean the aerator periodically by removing it from the mixer faucet and placing under running water in the direction opposite
to the one it operates, or using a small brush. This will help maintain a good water flow.
9- Nipple G 1/2"x 1/2"(x2) -
Not included
1- O-ring
2- Aerator
3- Metal washer (x2)
4- Surface flange
5- Flexible part (x2)
6- Quick connection nut
7- Connector thread
8- ABS washer
Attach the components in the same order as
illustrated above. We recommend that the control
remains to the right.
Connect the flexible parts (5) to the mixer faucet,
tightening them by hand. When threading them
in, avoiding twisting the parts.
The hole dimension is Ø 35 mm, and the worktop
must be no more than 30 mm thick.
Attach the components in the same order as
illustrated above.
ATENTION!
Before installing the mixer faucet, open the valve and let abundant water run to remove any dirt from the pipes.
• For a good performance, the pressure of hot and cold water must be the same.
• The mixer faucet should be installed at a point with minimum pressure of 5 mH2O. and maximum pressure of 40 mH2O. (mH2O =
meter of water column).
• Never use toxic products on the inlet threads.
• Connect flexible parts without sealing tape.
•
Avoid using wrenches
in the chrome-plated and/on stainless steel parts. If their use is needed, protect the part well.
•
Do not use wrenches on any flexible parts
, hand-tightening them is enough.
• The water temperature should not be above 90 °C.
All installation expenses are the client's responsibility. We recommend hiring a qualified professional to install the mixer
faucet.
After installation, we recommend running the water for a few seconds, observing all connectors. After that, with the mixer
faucet off, observe whether everything is properly sealed.
Note: The images in this manual are for illustration only. The manufacturer reserves the right to make changes to the products whenever
they consider necessary, or in the user's interest, without modifying essential characteristics of operation and safety.
installation
Revisão 1 / September 2018 / 200597
8