- 4 -
INSTALLATION
POWER SUPPLY
This wine and beverage center is equipped with a 115V/60Hz single phase motor.
Do not use a ground-fault circuit interrupter (GFCI) outlet to connect the unit. (Fig. A.)
The power plug is a standard grounded three-prong non-polarized flush mount,
which allows for easier connection to power outlets.
Power plug must be connected to the outlet directly, and never to an extension cord.
POWER CORD
Never shorten or lengthen the power cord. Do not fold or coil the power cord.
IMPORTANT
- Never place the excess length of power cord into the compressor enclosure in the
back of the wine and beverage center. This action creates a dangerous heat build-up which can
melt the cord, cause an electrical hazard and may potentially cause a fire.
Touching the power cord to the compressor at the back of the unit during operation can create an
electrical hazard and damage the compressor.
If the power cord is damaged, it must immediately be replaced by a trained service provider, as
special tools are required.
CLEAN BEFORE USE
To remove any manufacturing dust and residual odors, wipe the wine and beverage center inside and
out with a damp cloth and a solution of baking soda and warm water (2 tbsp. baking soda to 1 qt.
water). Wipe away any residual baking soda with a clean moist cloth. Allow to dry before operating.
Periodically clean the wine and beverage center with a sponge or cloth moistened with mild soapy
water, or baking soda and water.
PROTECT FROM MOISTURE
Heavy moisture in the environment can cause degradation to the insulation, as well as rust to the
cabinet, compressor and/or power supply.
Do not spray the wine and beverage center with water.
PROTECT FROM HEAT
Place the wine and beverage center away from heat source or direct sun.
Do not operate your wine and beverage center outdoors or in an environment with high
temperatures and/or high humidity, such as garages, attics or outdoor patios. The temperature
variances will create condensation on the glass door.
Do not cover the wine and beverage center with tarps or other items while operating, as this may
cause overheating.
IMPORTANT:
Do not cut or remove the third ground prong from the power cord.
IMPORTANT:
Never use with an extension cord. Power cord length is 5 feet long (1524 mm).
TEST
RESET
Fig. A
