Trainworx CLS-87520 Assembly Instructions Download Page 2

B1

B1

B2

B2

B3

B3

B4

B4

B5

B6

B7

B7

B6

B5

B8

B8

STEP 1: BASE

Assemble the base 

as shown using the 

key numbers for 

placement.

STEP 2:

FENCE POSTS

& INCLINE 

SUPPORTS

Assemble incline supports as shown in insets. 

Position fence posts and incline supports on base 

as shown but do not glue yet. 

Note that gate posts (P2) are taller 

than fence posts (P1).

STEP 3:

CROSS SUPPORTS, DIAGONAL 

BRACING, LOADING DOCK

 

Attach crossbars and diagonal 

supports to uprights as shown.

Thank you for purchasing TW Trainworx Stock Pen/Corral Kit. 

Livestock shipped by rail required frequent rest and water stops, so structures like these were placed at 

intervals along the rail lines in all parts of the country.  This is an accurate scale representation of a typical 

railway stock pen as used from the 1800s until the 1970s. 
Study the drawings and steps carefully before assembly so that you are familiar with the parts and procedures 

detailed in these instructions. Use carpenters glue or CA for assembly. Check parts against the drawings below 

to ensure that nothing is missing. If any parts are missing or damaged, contact us and we will send replace-

ments at no charge.
The kit may be painted or stained/weathered as you prefer. If you want the look of unpainted weathered wood, 

it is advisable to stain the parts before assembly and gluing, as the glue may keep the stain from covering 

completely. If you are painting the model this may be done after the kit is fully assembled using brush, airbrush, 

or spray cans. Board fences were typically whitewashed; some post-assembly weathering may also be desired.
Take your time and test-fit parts before final assembly. Allow two or three evenings for the assembly 

and painting of this model.  

P2

X1

X1

X1

X2

P1

G8a

G8b

G9a

G9b

G1a

G1b

G2a

G2b

G3a

G3b

G4a

G4b

G5a

G5b

G6a

G6b

G7a

G7b

F1

F2

F3

F4

F5

F6

F7a

F7b

F8a

F8b

F20

F21

B1

B2

B1

B3

B4

B2

B6

B7

B4

B5

B6

B5

B8

B3

B7

B8

F9

F10

F11

F12

F13

F14

F16

F18

F17

F15

F19

G8c

G9c

G6c

G5c

G4c

G3c

G2c

G1c

G7c

P2

P1

P1

P3

P4

X3

P3

P4

©2013 TW TRAINWORX • Dallas, TX • MADE IN U.S.A.

CLS-87520

CLS-87520

w w w.

t w

t r a i n w o r x . c o m

Make sure assembly

is perfectly flat and that all

joints are flush. Use masking 

tape to hold parts in position.

Allow sufficient time for glue

to dry completely before 

proceeding.

Place parts on a flat surface, 

apply glue to the mating

surfaces of the tabs.

NOTE: SOME PARTS ARE FRAGILE!

 Use a #11 hobby knife or similar tool to cut the thin tabs of material that hold the parts in the sheet

Reviews: