www.TrailFX.com
Page
4
of
9
Rev 010115
8.
Repeat
Step 3
to assemble the driver side Center Mounting Bracket and Support Bracket. Bolt the Bracket assembly to the
8mm Threaded Insert with (1) 8mm x 30mm Hex Bolt, (1) 8mm Lock Washer and (1) 8mm Flat Washer,
(Figure 8)
. Do not
fully tighten hardware at this time.
9.
Next, move along the side of the vehicle toward the rear tire opening. Remove the plastic wind deflector attached to the
bottom of the body panel,
(Figure 9)
.
10.
Locate the factory holes in the bottom of the floor panel in front of the rear suspension mount,
(Figure 10B)
. Select (1)
10mm x 12mm Double Bolt Plate,
(Figure 10A)
. Insert the 10mm side of the Bolt Plate first into the large oval hole and out
the smaller round hole,
(Figure 10B)
.
(Fig 10A) 12mm-10mm Bolt Plate
Rear
(Fig 9) Remove rear deflector
Front
Fig 8
8mm x 30mm Hex Bolt
8mm Lock Washer
8mm Flat Washer
(2) 8mm x 20mm Hex Bolts
(4) 8mm Flat Washers
(2) 8mm Nylon Lock Nuts
(Fig 10B) Insert 10mm end of Bolt Plate into
the oval slot and out the smaller round hole
Rear
