www.TrailFX.com
Page
3
of
6
Rev 022818
Driver/Left Side Installation Picture
(Fig 1) Insert flat blade screwdriver into square
opening in center of plastic clip to release
(Fig 2) Release both sides of clip and pull
insert to release. Do not try to pull the clip
out of the trim, only release clip as pictured
(Fig 4) Assemble 8mm Insert Tool
Tool
Handle
8mm
Hex Nut
8mm x 35mm
Hex Bolt
8mm Flat
Washer
8mm Threaded Insert
(Fig 3) Driver side front and rear mounting locations
Front
Mark and drill 7/16”
holes for 8mm U-Bolt
Mark and drill 3/8” holes
through pinch weld
(Fig 6A) Fully installed
Threaded Insert
(Fig 5) Assemble 8mm Insert Tool
Hold 8mm Hex Bolt in position with wrench.
Turn 8mm Hex Nut clockwise to “pull” insert