www.TrailFX.com
Page
3
of
5
Rev 110916
Passenger side installation pictured
Passenger side installation pictured
3.
Move toward the rear of the vehicle. Remove the factory body mount bolt as described in
Step 1
. Select the driver side Rear
Mounting Bracket,
(Figure 4)
. Bolt the rear Mounting Bracket in place as previously described in
Step 2
,
(Figure 5)
.
4.
With assistance, position the Sidebar up to the front and rear Mounting Brackets.
IMPORTANT
: There are two slots in each
Mounting Bracket,
(Figure 4)
. Select the appropriate mounting position:
a.
1999-2013 1500
: Use the lower mounting slots.
b.
2014-on 1500
: Use the upper mounting slots.
c.
1999-2015 25-3500
: Use the lower mounting slots
d.
Attach the Sidebar to the Brackets with the included (2) 1/2” x 2” Hex Bolts, (2) 1/2” Lock Washers and (2) 1/2” Flat
Washers,
(Figures 6 & 7)
. Do not tighten hardware at this time.
5.
Level and adjust the Sidebar, tighten all hardware and check all mounting locations for clearance between factory steel body
mount brackets and Mounting Brackets. Once satisfied with fit, tighten all hardware.
6.
Repeat
Steps 1—5
for driver Sidebar installation.
7.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Front
Front
(Fig 1) Passenger/right front Mounting Location
Factory body mount bracket
Factory body bolt,
2014 1500 pictured
Factory body bolt
(Fig 2) Passenger/right front Bracket
(Fig 3) Passenger/right front Bracket
