www.TrailFX.com
Page
1
of
8
Rev 062816
30-60 min
DRILLING
REQUIRED
CUTTING NOT
REQUIRED
DO NOT OVER
TORQUE
.
STANDARD OPERATING LOAD FOR TIGHTEN
BODY MOUNT NUTS & BOLTS VARIES FROM
45
TO
65
FOOT POUND.
Tools Required
Phillips Screwdriver
Power Screwdriver with Phillips bit
T30 Torx Head Driver.
INSTALLATION PROCEDURE:
WARNING:
Do not transport a pickup truck facing backward with a liner installed.
Air can get under the liner which may result in the liner coming out of the truck and causing damage or injury.
Truck Box Preparation:
Clean truck box of all foreign matter and open any floor drains to ensure ventilation and moisture drainage.
NOTE:
Bed liner can be installed by one person. However, using two people is recommended by the manufacturer.
1. Tailgate Cover Installation Steps
NOTE:
Your tailgate cover kit may have more or less hardware than shown.
`
FORD F-SERIES STYLESIDE &
FLARESIDE
Part No.
23004X
23006X
23006ZX
23007X
23010ZX
23011ZX
23012ZX
23013X
23104X
Do not over tighten as screws can be stripped out.
Limited Lifetime
1 866 638 4870
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
STEP 1
Center tailgate cover on truck tailgate, locating any factory
screws at predrilled hole locations. Remove these screws and
set aside for later use. (See FIGURE 1)
STEP 2
Place washers on screws previously removed. (See FIGURE
2) Reinstall FIGURE 1 screws with washers and tighten down
tailgate cover.
