Trailer Vision DR-220N Instruction Manual Download Page 3

22

7

2 CH DRIVING VIDEO RECORDER

Specifi cations

0.3M pixel WDR(Wide dynamic Range) CMOS sensor (H : 95° / V : 70° / D: 125°)

VGA (640x480) 

30fps*2

Ordinary / Event 

Ordinary : It continues recording at intervals of 2min.

Event : 10 sec. before and 20 sec. after an event happens (30 sec. in total)

AVI (H.264) 

SD Card (max.64GB)

Internal (5 step)

Internal (or supported external GPS) 

DC 12~24V (with super cap) max.32V

12V / 350mA

-50°F ~ 140°F  (-10°C ~ 60°C)

-68°F ~ 158°F  (-20°C ~ 70°C)

4.13 x .87 x 2.64 / lens 1.52 in  (105 x 22 x 67 / Lens 38.5 mm)

5.4 oz / 154 g (with Bracket)

Camera

Recording

Compression

Memory

G-Sensor

GPS

Power

Operating Temperature

Storage Temperature

Dimension (W/H/D)

Weight

OUT

Resolution

Frame

Mode

Time

Voltage

consumption

Signle chip 1/4” CMOS Sensor

H : 120° / V : 89.5°/ D : 154°

0.1 lux

DC 12V / 120mA Max.

-20°C ~ 60°C

45 x 27.5 x 31 mm

30g (with Bracket)

* External camera (CM-100S)

Pick-up Device

View of angle

Min. Illumination

Input Voltage

Operating Temperature

Dimension (W/H/D)

Weight

3

2 CH DRIVING VIDEO RECORDER

Safeguard Instructions

GPS antenna must be free of any obstructions, ex. navigation systems.

- It may cause problem with GPS signal reception.

GPS function requires acquisition time when powered on. 

- Signal acquisition may take a few seconds or longer depending on operating environment.

Do not place product in location that is subjected to rapid temperature changes or high humidity. 
Always use optimum voltage. Failure to do so may result in electronic shock or malfunction.

Metallic tinting on front window may cause reception problems, poor recording quality or GPS 
reception problems.

SD Card must be rated at class10 or higher to function properly.

  

- This product supports up to 64GB.

Do not pull out SD card while working status such as data backup and format.

- It may cause a serious damage on SD card.

Please insure power is off prior to removing SD Card.

- If you pull SD card out during power on status, it may cause malfunction or data loss.

SD card is consumable. SD Card will become worn or damaged with prolonged use.

SD Card has a limited life expectancy and will vary from manufacturer to manufacturer.

- If you find data lose after long time usage, please replace with a new SD card.

Important data should be backed up on a separate storage device. 

- Data will be overwritten with long term use. 

Please Note: We are not responsible for Loss or damaged data caused by im-
proper use, see below.

Summary of Contents for DR-220N













Reviews: