Trafomatic Audio LARA, User Manual

Page: 8 / 15

LARA - LINE LEVEL Preamplifier - U ser Manual
06
LARA - LINE LEVEL Preamplifier - U ser Manual
PACKAGING
Save the original packaging in a dry place. The packaging has been designed to protect your
device from stresses incurred during shipping. Using packaging different from the original in -
creases risks of shipping damages
PREPARATION FOR USE
Place your preamplifier on a flat, stable surface.
Power switch, located on the left side of the power supply unit should be in the OFF (0) po -
sition.
Make sure that the voltage selector switch (located on the rear panel, next to the AC inlet)
is properly set:this switch needs to be set so that the number displayed (115 or 230) corre -
sponds with the line voltage in your country.
Connect the power supply unit with the preamplifier unit by using provided power cable.
Plug in the power cord.
Connect LINE OUT of the LARA to line inputs of your amplifier. If applicable, connect sub -
woofer to the SUB OUT connectors.
Connect your audio sources to the preamplifier’s inputs (L1 through L3 and XLR1, XLR2).
If some of your sources require signal grounding (turntable tonearm, for example), connect
the wire to the grounding lug (GND) on the rear panel of the preamplifier.
By using the front panel input selector switch, select the appropriate audio source (L1 through
L3 and XLR1, XLR2).
Make sure that volume control is set to minimum position.
Turn on the LARA by using power switch located on the left side of the power supply unit.
Turn on your power amplifier.
Slowly increase volume, to make sure there are no unusual noises coming out of the speak -
ers.
CONGRATULATIONS! You are all set and ready to enjoy high sound quality of the LARA
Line Level preamplifier.