Traeger BBQ075.01, Owner'S Manual

Page: 4 / 22

SECTION ONE: ASSEMBLY INSTRUCTIONS
MOUNTING THE LEGS:
1) Carefully lay the Grill on its back on a non-abrasive surface.
2) Use the
Black Bolts (A), Washers (E, G) and Nuts (C) supplied in the hardware
kit to install the Caster Leg Assemblies (99) on the left end of the Grill and the
Wheel Leg Assemblies (104) on the right end of the Grill, as shown in the upper
diagram below. The Nuts (C) on the Wheel Leg Assemblies (104) should go
toward the center of the Grill. You may need to rotate the Grill toward the back to
accommodate the Leg Assemblies (99 & 104) on the rear of the Grill.
Leave the
Nuts loose during this step.
3) Set the Grill upright to level and then tighten all Nuts.