Traditional Tool Repair DSA-116, Operation, Parts And Safety Manual

Page: 2 / 2

OPERATING INSTRUCTIONS
1. Fully open the sealer handles and center the open jaws on the seal. See Figure 1.
2. Bring the sealer handles together completely together to assure a proper notch. See Figure 2.
3. Remove the sealer. Place the sealer on the opposite end of the seal and bring the handles completely together.
Remove the sealer.
NOTE: If the gauge of the strap being used will not allow it to be bent, cut the strap supply as close to the seal
as possible using an approved strap cutter.
4. To avoid contact with the sharp end of the strap, retract the strap end back into the strap dispenser.
PARTS LIST
DSA116 DSA218
KEY QTY. PART# PART# DESCRIPTION
1 3 003911 003911 Flexloc nut, thin, 5/16-24 When ordering parts, please show tool
2 2 004033 003971 Side plate model, part number and name.
3 4 004037 003974 Jaw pin
4 4 004039 003977 Jaw All recommended spare parts are
5 2 004038 003976 Notcher pin underlined and should be stocked.
6 2 004041 003991 Notcher
7 1 306183 306193 Upper handle assembly Standard hardware parts may be obtained
8 4 004036 003973 Link pin from local hardware suppliers.
9 1 003907 003907 Rear link
10 1 003906 003906 Front link
11 3 004034 - HHCS, 5/16-24 x 1 7/16
3 - 003972 HHCS, 5/16-24 x 1 5/8
12 2 082630 082630 Grip
13 1 306184 306194 Lower handle arm assembly
14 1 003132 003132 Caution plate
15 1 584-1172 584-1162 Nameplate
For Parts Support Call 1-
877-862-6699
MAINTENANCE
Inspect tool daily for worn or broken parts and
replace if necessary. Clean and apply light machine
oil to all moving parts - weekly.
WWW.TRADITIONALTOOL.COM
For Parts & Service 1-877-862-6699