INSTALL BLADE TO ARBOR
MAKE SURE THE SAW IS DISCONNECTED FROM
THE POWER SOURCE WHEN INSTALLING THE
BLADE.
1. Remove the table insert (1) by removing the 2 screws (2 &
3) that hold it in place (see Fig. 7).
NOTE: Be careful not to lose the rubber washer that is on
the back screw (3) beneath the insert.
2.
Raise saw blade arbor (4) to its maximum height by
turning the blade raising hand wheel counterclockwise (see
Fig. 8). Remove the arbor nut (5) and outer flange (6)
from the saw arbor.
3.
Place the saw blade on the arbor making sure the teeth of
the blade point DOWN at the front of the table.
4.
Place the flange (6) and arbor nut (5) on the arbor and
tighten the nut as far as possible by hand making sure the
saw blade is firmly seated against the inner flange (7) (see
Fig. 8).
NOTE: Make sure large flat surfaces of flange and nut face
INWARD toward the saw blade.
INSTALL BLADE TO ARBOR – Cont’d
5.
Place the open end blade wrench (8) on the flats of the saw
arbor to prevent the arbor from turning while tightening.
Using the box end blade wrench (9) tighten the arbor nut
by turning it clockwise. (See Fig. 9).
MAKE SURE THE SAW BLADE, ARBOR FLANGE AND
NUT ARE PROPERLY SEATED AND ARBOR NUT IS
TIGHT.
6.
Replace table insert and fasten in place with two screws (2
& 3).
Be sure rubber spacer is under table insert on
rear screw. Tighten rear screw #3 until insert
plate is level with table top in this area. Failure to
level insert plate in this area can cause work to
stick/jam and could possibly cause serious injury.
ASSEMBLY
CAUTION
!
CAUTION
!
Fig. 7
Fig.8
Fig.9
CAUTION
!
12
