3
Suits 3 core 1.5mm
2
and 2.5mm
2
cables.
Interior Wiring Instructions:
• Strip the cable sheath and insulation and prepare flex cable as shown above.
• Loosen the terminal screws and ensure adequate space to insert cable.
• Connect Earth wire with Green/Yellow stripe insulation to Earth terminal (marked with “E” & Green indicator)
and tighten the terminal screw.
• Connect Brown (or Red) insulation wire to Active terminal (marked with “A”) and tighten the terminal screw.
• Connect Blue (or Black) insulation wire to Neutral terminal (marked with “N”) and tighten the terminal screw.
• Make sure bare wires are fully inserted into the terminal and there are no loose strands of wire.
• Double check Active, Neutral and Earth wires are connected to the correct terminals and all conductors are
tightened by terminal screws.
• Fit the cable clamp over the cable sheath and tighten the screws. Make sure minimum of 3-5mm sheath must
be beyond the end of the cable clamp. Do not clamp on conductor insulations. Ensure cable sheath
is gripped securely after cable clamp screws tightened.
• Check the wires are in their correct position as shown and terminal screws are tight.
• Mount the plug base back to the unit body and tighten the screws.
Identification:
Fitting Instructions for Plug Base:
N
E
A
Outer
Sheathing
Insulated Cores
Earth Wire
Green/Yellow Stripe
Bare
Wires
8mm
30mm
Foam
Gasket
Rubber
Gasket
Mounting
Flange
Weather proof
flap
