Aug_19
Product Code: 1198T
Made in China to TQB Brands Pty Ltd Specifications
Page 3
Visit us at www.tqbbrands.com.au
ASSEMBLY, OPERATION & PREVENTATIVE MAINTENANCE
1.
FEATURES
TradeQuip Auxiliary Parts Stands are intended to be used as a means of partial support and the positioning of vehicle
components during their installation/removal. The Auxiliary Parts Stand is not for use in stabilising or supporting vehicles. These
are for use under a 2 or 4 post overhead vehicle lift or in a garage pit. Heavy gauge steel construction to ensure safety, strength
and stability.
2.
ASSEMBLY
Insert smaller end of threaded column through the bottom of upright, allowing small end of threaded column to project
out of the top of upright.
Place bearing over threaded portion with upright/threaded column assembly in the horizontal position.
Spin adjusting handle clockwise onto threaded portion.
Insert the roll pin through saddle & threaded column to fasten saddle.
Insert upright assembly onto base with slot in upright facing foot pedal mount.
Secure upright using the larger pin, washer and r-clip.
Insert pedal into slot and secure with remaining pin, washer, and r-clip.
3.
BEFORE USE
Conduct a thorough visual inspection checking for any abnormal conditions, such as cracked welds, and damaged, loose, or
missing parts.
4.
OPERATION
Prior to each use always conduct a visual inspection checking for any abnormal conditions, such as cracked welds, and
damaged, loose, or missing parts.
To Raise:
Turn adjusting handle clockwise until saddle contacts load. Be sure to centre load on saddle.
Slight upward adjustments can be made to the saddle height by pressing downward on the foot pedal.
This may or may not be necessary depending on the application. It is provided as a means of making temporary
adjustments on load height without using your hands. This leaves your hands free to engage, handle and control the
workpiece.
WARNING
The stands must be positioned on a hard level (concrete) surface.
The safe working load must not be exceeded under any circumstances.
DO NOT lower overhead lift in order to accommodate load on stand.
Contact with the desired vehicle component shall only be done by means of the vertical adjustments provided on the
stand.
Always centre the component load on the saddle.
To Lower Vehicle:
Turn adjusting handle counter clockwise
Carefully remove stand from underneath vehicle.
Slowly lower vehicle to the ground with overhead lift hoist control.
5.
STORAGE
These Jack Stands should always be stored in a dry indoor location in the upright position.
6.
MAINTENANCE
Periodically inspect each stand. Ensure all parts move freely. Do not apply oil or grease to any part of this product. If rust
appears, sand the affected area and cover with suitable paint. This product has no replacement parts.
7.
SERVICE & REPAIR
Any Auxiliary Parts Stands found damaged in any way, or found to be worn or operates abnormally should be removed from
service until repaired by an authorised service agent. Owners and / or operators should be aware that repair of this product
may require specialised equipment and knowledge. Only authorised parts, labels, decals shall be used on this equipment.
Annual inspection of the Jack Stands is recommended and can be made by an authorised repair facility to ensure that your
equipment is in optimum condition and that the equipment has the correct decals and safety labels specified by the
manufacturer.
