10/21
Product Code: 1027T
Made in China to TQB Brands Pty Ltd specifications
Page 5
Visit us at www.tqbbrands.com.au
4.
STORAGE
This TradeQuip Evaporative Cooler should always be stored in a dry location away from elements on a level surface. When
you stop using the fan, you should clean the fan, pack it and put it in dry places, and be careful not to damage the fan.
5.
MAINTENANCE
Disconnect power prior to any maintenance
Inspect the general condition of the TradeQuip Evaporative Cooler checking:
•
for loose hardware
•
cracked, bent, or broken parts, and
•
any other condition that may affect the TradeQuip Evaporative Coolers safe operation
For best results and long term operation, regular maintenance is essential.
To ensure the cooler delivers fresh and clean air, regularly change the water when dirty, and clean both the dust filter and
the cooling pad.
1.
Remove the filter pad by unscrewing the 4 screws on the rear of the cooler. Then lift the pad and pull out at the bottom
to release. To replace the pad, slide up into the slot under the top of the cooler, push in at the bottom; and allow to drop
into the lower slot.
2.
Clean the pad from the inner-side to out-side of pad (inner side is towards motor).
3.
Never use any liquid detergent. Never use pressurized water, as it may cause damage to the pad.
4.
Unscrew the drainage lid to let dirty water flow out, then clean the water tank thoroughly with a soft cloth. Wash off
dirt on the water sensor, water pump and the float valve. Rinse thoroughly.
5.
Use mild soap and soft clean cloth when cleaning the cooler casing. Do not use any caustic chemical detergent that may
cause damage to the surface of the cooler.
6.
To prevent build-up of algae and other biological organisms in the reservoir, regularly add chlorine/bromine tablets as
per tablet manufacturer recommendation for evaporative cooler reservoirs.
6.
SERVICE & REPAIR
Any TradeQuip Evaporative Cooler found damaged in any way, or found to be worn or operates abnormally should be
removed from service until repaired by an authorised service agent. Owners and / or operators should be aware that repair
of this product may require specialised equipment and knowledge. Only authorised parts, labels and decals shall be used on
this equipment. Annual inspection of the Pedestal & Wall Fan is recommended and can be made by an authorised repair
facility to ensure that your equipment is in optimum condition and that the equipment has the correct decals and safety labels
specified by the manufacturer.
