11
Now that you have installed the TracVision R6ST
system, you need to turn the system on and
verify that the antenna works properly.
a.
Ensure the antenna has a clear view of the
southern sky.
b.
Apply power to the TV, receiver, and the
TracVision R6ST system.
c.
Turn on the power switch on the front of
).
d.
Wait while the antenna searches the sky
for the satellite. Within a few minutes, all
three status lights on the front of the
receiver should be lit green.
NOTE:
If all three status lights are not lit
green, refer to the User’s Guide for
troubleshooting information.
e.
A progress bar will appear on the TV,
indicating that the receiver is
downloading the program guide (see
NOTE:
The receiver might take up to one
minute to load the program guide.
f.
Once the program guide is loaded, verify
that you can view the DIRECTV preview
channel (channel 100).
Test the System
9
Figure 19 Receiver Status Lights
Figure 20 Program Guide Progress Bar
Status Lights
Power Switch
Installation
If your satellite dish is ready for DIRECTV
®
service, please wait until your
Advanced Program Guide™ is prepared.
Acquiring guide data...
