TracVision R5SL/R4SL
5
RF PCB Replacement Instructions
Step 2 - Check the Main PCB Software Version
You might need to update the software in the TracVision system’s
main PCB, depending on its software version. The following
instructions explain how to check the currently installed main PCB
software version. This procedure requires a PC with the Flash Update
Wizard installed.
a.
Connect one end of a PC serial data cable to the DB9
maintenance port, located on the switchplate. Connect
the other end of the data cable to the serial port on your
computer.
TIP:
You can purchase a PC serial data cable from KVH
(KVH Part #32-0628-06).
TIP:
If your computer does not have a DB9 serial COM port, you can
use a KVH-tested USB adapter. Refer to the Flash Update Wizard’s
Release Notes for more information.
Figure 6 TracVision Switchplate
b.
Double-click the KVH Flash Update Wizard shortcut on
your PC’s desktop to start the Flash Update Wizard.
TIP:
You do not need to flash the antenna; you will simply type
commands in the Flash Update Wizard’s “TracVision Antenna
Comms” window.
c.
Set the switchplate’s POWER switch to the on (up)
position, then turn on the receiver(s). Wait one minute
for system startup.
d.
Type
HALT
then press Enter.
e.
Type
VERSION
then press Enter. The antenna’s main
PCB software version will appear in the “TracVision
Antenna Comms” window. Be sure to record the
software version for later use.
f.
Type
ZAP
then press Enter.
Maintenance Port
(DB9 Connector)
ON
OFF
